Recent Obituaries Springfield, Mo, Nombre Que Combine Con Adrian, Best Ingredients For Combination Acne Prone Skin, Articles D

I am satisfied with my fe1 suspension with upgraded sway bar. We have a 2010 Impala with FE1 suspension and a leaky Rack. I bought new readi-struts (new springs mounted on new struts ready to install) for my '10 LT a couple years ago, without checking here first, but it is my understanding now that there are 3 levels of suspension for the 3 levels of trim. FE3 and FE5 do share the cast aluminum control arms, just make sure you do not get '08+ FE5 control arms, as they will not fit (the knuckle interface is different). Fasterproms Ported Intake Manifold w/LS3 TB. This translates into a far more precise feel from the suspension and steering. And over the same roads, the CTS took the pot holes and rough pavement much easier. //-->. Front Stabilizer Bar (mm) - Base and F45 suspension 23x3.8mm The Z51 Bar is 25.4x4mm. Does a 2007 Chevy Impala have struts or shocks? ---------- Post added at 11:34 PM ---------- Previous post was at 11:33 PM ----------. And thats lower than the average for other vehicle models, which is $650. GM Sirius Connect SIRGM2L - INSTALLED (No more XM!!!) Three suspension tuning levels are available: FE1 (standard), FE2 (standard on 3.6L models and optional on 3.0L models) and the FE3 sport suspension with a summer-only tire (RWD only). In this case, FEx identifies a suspension tune, the specifics of which may also depend on the year of production. The 'Touring' (or FE1) set-up is used on Evoke, Calais and Calais V; the 'Sport' FE2 is reserved for SV6, SS and SS V; and the 'Track' FE3 suspension is available on SS V Redline only. FE2 Suspension question. Aurora General Discussion. 06-11-2021 03:33 PM by USMCFieldMP. What is the difference between FE1 and FE3 suspension? All 2012-2013 Impala Models with FE3 Suspension. 2007 Ion 2 Quad Coupe 5-speed manual 183K miles *gone*, Lower control arm differences for FEx suspension. FE1 is the "Corvette Standard Suspension" and FE3 is the "Corvette Sport Suspension." There are two sub-levels of shocks available on the FE1. 4. Forum Features & Navigation. Suspension Springs, Shocks, Brakes. While they dampen bounces like a shock, they also provide the structural support for the suspension of the vehicle, holding tires in alignment and supporting springs. The FE3 suspension is a thicker rear swaybar, different rear springs, and front and rear shocks/struts. Assuming nothing has been swapped since the car left the factory, look at the wheels and tires. Difference between FE1 and FE3? google_ad_height = 90; The FE1 doesn't obviously but.. Basically the FE3 suspension is the regular suspension which comes with the Camaro SS. 2007 ION-2 Sedan. Exterior. All you want are the sway bars and bushings. FEUX ARRIERES ROUGES LIGHT BAR AUDI Now FE3 is the start of the performance suspension ending with the FE5. I went onto A1 auto and was looking at suspension for my 2007 Chevy cobalt LS FE1 model suspension. Also in S Pack and more recently SV8/SV6. Members Ride. Im leaving to somewhere soon and ill be gone for a long time. These are the base shocks and the F55 magnetic shocks. Feb 1, 2018. For a majority of people, this base (FE1) suspension is perfect. Best regards, Tyler. It feels planted, corners flat but doesn't beat you up with a harsh ride. vc commodore. 2012-2013 Impala FE1, FE2 suspension Rack And Pinion . Struts are a major part of the suspension in your Chevrolet HHR. Automotive Network, Inc., Copyright 2023, http://www.fme-cat.com/Application.aspx?year=2004&make=CHEVROLET&model=CAVALIER&engine=L4%202.2L%202198CC/134CID%20VIN%20F%20L61&subm=BASE%20MODEL&cat=Suspension&subcat=Suspension,%20Springs%20and%20Related%20Com, http://i253.photobucket.com/albums/hh68/J-Ri/FE1vsFE2.jpg. FE3- suspension system, sport. theres a sticker in the trunk under the mat on the left side. google_ad_client = "pub-8306900413359372"; Labor costs are estimated between $179 and $226 while parts are priced between $431 and $432. At its most basic, the C5 and C6 Corvette suspension uses upper and lower A-arms suspended by transverse leaf springs made of fiberglass. Since its launch, the regular CTS has been available with three different suspensions, FE1, FE2, and FE3. FE3 = option code for uplevel suspension. FE1 is the "Corvette Standard Suspension" and FE3 is the "Corvette Sport Suspension." There are two sub-levels of shocks available on the FE1. 2011 HSV GTS. check out the. The FE1 with the heavier sway bars gives a soft but stable ride, and I'm happy that way. Open your trunk, lift up the cover over the spare tire area, turn it over and you will see a label with all of the option content RPO's alphabetically listed. Mainly the difference between the FE3 and FE2 is that FE2 has smaller stabilizer bars, softer springs, softer bushings everywhere, less aggressive dampers, strut/suspension braces deleted and more steering ratio (takes more turning to go lock to lock). Home is the beautiful Pacific Northwest. (MSRC upgrade) comparisons. FE2 usually sits 1-1.5 inches lower than standard, beats driving around in a 44. Happiness: Infinite. How Reliable is the Chevrolet HHR? You must log in or register to reply here. FE2 is the stock suspension setup that comes in an SS. F40 (FE4)- suspension system,Heavy Duty Front and rear. (stiffer suspension, better handling etc). At first, many people are surprised to find out that a car as . thatll tell you which one you have. FE3 is the handling part of the Z51 package (the rest of the Z51 package is the coolers and tires). GM realized this and offered the "Z51" (FE3) option package which, among other things, increased the spring rate on the suspension. Nobody locally has them in stock, so I can't get both and compare. Anyone noticed flat spotting with the Michelin Pilots HXMXM4? https://visualizer.chevrolet.com/ui?US&channel=b2c, https://www.midenginecorvetteforum.c-press-release, https://www.midenginecorvetteforum.cand-visualizer, https://www.midenginecorvetteforum.crs-information, https://www.midenginecorvetteforum.ctte-e-ray-leak, https://www.midenginecorvetteforum.cecommendations, https://www.chevrolet.com/performancd-price/config, https://www.gmfleetorderguide.com/NAD=22412&type=0, https://www.midenginecorvetteforum.cfreight-charge, https://www.midenginecorvetteforum.cup-and-running. Stiffer front stabilizer bar than FE1/2 and a rear stabilizer bar. What is FE1 suspension? The stock suspension is with the non sport suspension type which is with softer comfortable ride. The lower control arms on the FE1 suspension are steel, while on the FE3 suspension, they are aluminum, but they are dimensionally the same. I then keep those reports in my file for each car. To review, my CTS has the 3.6L engine, but the base FE1 suspension. . By comparison, the CTS FE3 was considerably more civilbut then its also a much heavier vehicle. Ins cos notify manufact of even minor damage, and manufacts love to save money. Tim. JavaScript is disabled. google_ad_slot = "4972140983"; You have a placard in your trunk that tells you what you have, it lasts all your option codes. My apologies for digging up an older thread What SINSTR6 said, my understanding is that the only difference is thicker swaybars, springs and shocks are the same. 2008 CTS 3.6L DI RWD, GMPP new engine 11/2013. I'm about to be in the market for new control arms, since I'm sure the balljoint and bushing needs to be changed, so imma do em all at once. It takes just a moment to join our fantastic community. google_ad_client = "pub-8306900413359372"; That is free to try! and 2) if i can put FE3 struts and springs. Service writers can also print out the service hist of the car, date of in-service, if it has extended warranty, if it has a blocked warranty, etc. My 2003 Ion does not have FE1 suspension from what I gather but will a control arm for FE1 fit my car? FE4: Mag-Ride on Z51 Suspension. I am looking for the specification differences between the fe2 and fe3 suspension Things that I think I know but I am unsure of.. You can see the codes are in numerical order and that this vehicle came equipped with the Z55 Autoride suspension. For a better experience, please enable JavaScript in your browser before proceeding. ACNA Notice Board. Any RPO code simply refers to a specific option or modification to the vehicle as built during production. 5. We here at Diverse Suspension Technologies get this question a whole lot. What is the difference between Fe2 and Fe3 wheels? The CTS-V comes with the FE4 V-series suspension. Your mates would ride alot smoother, but handle, corner alot worse. How do I know what suspension My Cobalt has? theres a sticker in the trunk under the mat on the left side. google_ad_slot = "4972140983"; . Any info would be appreciated 8) . FE2 usually sits 1-1.5 inches lower than standard, beats driving around in a 44. I want to put the FE3 suspension on because it looks nicer and runs a little more to my liking. The (LTZ) FE3 suspension also includes a different steering rack. . FE3 v.s. Z85 is listed simply as Chassis package increased capacity in the upfitter manual. 2007 Ion 2 Quad Coupe 5 . /* 728x90, created 4/10/11 */ With the FE1 suspension the car feels vague and even sloppy. 2007 Impala LTZ standard suspension is FE1 while only the SS received FE3 18inch wheels Front is said to be hollow 30mm stabilizer bar FE3: hollow 34mm Rear FE1: 16mm solid FE3: 18?/19.4mm hollow Coil springs: FE1 has variable rate FE3: Dual rate Steering power rack and pinion 13.3:1 Wheels- 3.5V6 - 16x6.5, 3.9V6 17x6.5, SS5.3 18x7 I change my springs to balance a car. Reason is that if we are fortunate enough to have received ours, almost all of us have not driven another C8 with a different suspension configuration. What is the Difference Between Moog R Series and CK Control Arms? That's the only differences and you'll see about a half inch lift in the front.